Our latest product, the Tri-Dyne Tele-Pier (TDTP), affords contractors, and/or skilled homeowners the ability to re-level or adjust the elevation of a raised building structure. In keeping with Tri-Dyne's philosophy, the Tri-Dyne Tele-Pier will dramatically reduce building maintenance costs, and improve the serviceability and longevity of any raised-foundation type structure.

A BETTER SOLUTION: Adjust versus Repair. The telescoping pier is more efficient because installation is faster and cheaper. Once installed, the pre-cast Tele-Pier units are easily adjusted to compensate for settlement -- There is less mess and no need to move out for residential or commercial property owners. Once installed, The Tri-Dyne Tele-Pier is the below-market-cost solution to leveling any raised-foundation type structure. Installation is required by a licensed contractor.

• Increases Property/Resell Value
• Direct Replacement and Faster Installation (vs. cast-in-place, masonry, block, or stone pier's)
• Simplifies Foundation Maintenance by Reducing Leveling Costs
• Lifetime Transferable Warranty
  The Homeowner is not Required to Move out of the Home.

The objective in development of the Tri-Dyne Tele-Pier was to create a raised pier foundation system that incorporates a passive system for maintaining the elevation of raised homes, suitable for use on new or existing construction.

The Tri-Dyne Tele-Pier is designed for typical residential one to three story foundation loads.  If your project has special foundation load requirements, Tri-Dyne's Engineers will calculate the concrete strength and steel re-enforcement specific to your application.

The Tri-Dyne Tele-Pier is a patent-pending pre-cast reinforced concrete adjustable pier foundation system.

The Tri-Dyne Tele-Pier consists of a stationary outer pier section and a telescoping inner pier section.  In the event that the supported structure need to be raised or re-leveled, this telescoping arrangement allows lifting the supported structure using commonly available jacking equipment.  In this manner, re-leveling or raising a structure can be completed in a few hours time.

In a typical foundation application, the stationary outer pier section of the Tri-Dyne Tele-Pier is anchored onto a grade beam or spread footing by means of connectors and drilled fasteners. The inner, telescoping  portion of the Tri-Dyne Tele-Pier is attached to the structure's sill beam by means of an articulated metal beam seat.  The beam seat can is rigidly fastened to the structure's sill beam using nails through-bolts, or lag-bolts.  The articulated connection between the beam seat and the telescoping inner pier allows in-plane rotation of  the sill beam over the pier.  By allowing some rotation of the sill beam over the pier, permanent warping of the sill beam is eliminated.

The Tri-Dyne Tele-Pier installation does not requires any internal mechanical tooling (i.e. screw jacks, hydraulic cylinders). Externally lifting the structure from the sill beam is the most common method for restoring a structure to level. The engineering model and full-scale load tests have shown this product to be superior to currently available alternatives under both compression and lateral loads.

The Tri-Dyne Tele-Pier is a foundation system and leveling system that will provide lifelong service to your structure.  Because it is constructed of pre-cast concrete, Tri-Dyne can ensure the Tele-Pier's quality, durability and strength.